![]() If the error goes away when the Playback Engine is switched to Built-in audio, please contact Avid support so we can assist you further in troubleshooting any possible hardware issues. Audio Overload is a lightweight piece of software designed for the help you play the audio and soundtracks of the games of the 1990s with just one click. In the December issue of Stereophile, Mike Fremer describes the Esoteric E-03 phono preamp as: 'The MM gain is specced at 44db and the MC gain at 66db with ultralow noise specs of -137db/v (MM) and -140db/v (MC) with very comfortable overload margins of 180mv (MM) and 9mv (MC) presumably both at 1kHZ.Once you switch the Playback Engine, please test a Pro Tools session and see if the error re-occurs. Playing the music and soundtracks of the 1990s is a rewarding experience and there is a wide variety of players and programs that can help you do just that. To test, go to Setup > Playback Engine and switch it from your current interface to the Mac's Built-in Output or Pro Tools Aggregate.OR- try swapping connectors to different ports on the Mac and/or ports on the interface, if possible.Ĭheck if the -6101 Error is caused by hardware: Please try swapping to known good cables whether USB, Firewire, miniDigilink, etc. There may be a possible connectivity issue. If the interface that was used has a faulty connection or bad cable, there may be an interruption in the transmission of audio data. AUDIO OVERLOAD HELP DRIVERSMake sure drivers installed are compatible with both the OS version being used and the version of Pro Tools being used. But scientists need your help to make that happen.' The catalog contains more than 1.8 million photos, about 1.3 million of them from the space station and roughly 30 of them taken at night.Even if a device is physically disconnected, the drivers may still be installed and are still tied to the Mac's Core Audio. Removing any unnecessary variables is a must, so removing drivers not needed anymore will help. Also, make sure the current Audio interface being used is up to date on firmware and drivers. AUDIO OVERLOAD HELP DRIVERThere may be a driver conflict with other device drivers. If you have had older audio interfaces before your current audio interface on that same computer, make sure to completely uninstall any older drivers from that system.Using a discrete graphics card is recommended. This error message can be caused by the use of integrated graphics cards. ![]() Try removing VI's to see if that resolves the issue. ![]() AAE -6101 errors have been encountered in sessions at low buffer sizes with as few as one Virtual Instrument. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |